s3c2440al-40-yq80资料 | |
![]() |
s3c2440al-40-yq80 |
file size : 116 kb
manufacturer:samsung description:1. tolerance and type number designation the jedec type numbers shown indicate a tolerance of 5%. 2. zener voltage (vz) and impedance (izt and izk) test conditions for zener voltage and impedance are as follows: iz is applied 40 10 ms prior to reading. mounting contacts are located 3/8 to 1/2 from the inside edge of mounting clips to the body of the diode (ta = 25c 8c, −2c). 3. surge current (ir) surge current is specified as the maximum allowable peak, non−recurrent square−wave current with a pulse width, pw, of 8.3 ms. the data given in figure 5 may be used to find the maximum surge current for a square wave of any pulse width between 1 ms and 1000 ms by plotting the applicable points on logarithmic paper. examples of this, using the 3.3 v and 200 v zener are shown in figure 6. mounting contact located as specified in note 2 (ta = 25c 8c, −2c). 4. voltage regulation (dvz) the conditions for voltage regulation are as follows: vz measurements are made at 10% and then at 50% of the iz max value listed in the electrical characteristics table. the test current time duration for each vz measurement is 40 10 ms. mounting contact located as specified in note 2 (ta = 25c 8c, −2c). 5. maximum regulator current (izm) the maximum current shown is based on the maximum voltage of a 5% type unit, therefore, it applies only to the b−suffix device. the actual izm for any device may not exceed the value of 5 watts divided by the actual vz of the device. tl = 75c at 3/8 maximum from the device body. *not available in the 2000/ammo pack. |
1pcs | 100pcs | 1k | 10k | ||
型 号:s3c2440al-40-yq80 厂 家:samsung 封 装:bga 批 号:0827 数 量:3570 说 明:全新原装,特价出售 |
|||||
运 费: 所在地: 新旧程度: |
|||||
联系人:林浩/林妮 |
电 话:0755-82532799/82532766/83989559 |
手 机:13510168121/13725556003 |
qq:496982847/351622092 |
msn:linearic@hotmail.com |
传 真:0755-82532766 |
email:maxim_zi@126.com |
公司地址: 深圳市福田区佳和大厦b座1802室 门市部:华强广场 q2a114展销柜 |